Commissioning
8.2 Basic commissioning procedure
CPU 1515SP PC2 (F/T/TF)
44 Operating Instructions, 09/2018, A5E42603425-AA
When the requirements (Page 43) are met and the preparations for commissioning
(Page 43) are complete, proceed as follows with the commissioning:
1. Connect the power supply.
→ The PWR LED lights up yellow first, then green.
→ The device carries out the hardware initialization.
2. Wait until the Siemens logo disappears from the screen.
3. Follow the instructions on the screen to configure the device:
– Set <Language>, <Country/region>, <App language>, <Keyboard layout>, <Time
zone for>
– Accept license conditions
– Setting the account
4. Finally, you will be prompted to restart the device.
If you change the device during the installation, the installation will be disrupted and the
operating system will not be installed correctly. The operational reliability of the device and
the plant is endangered.
Do
switch off the device during the entire installation process.
Information on users/user groups in Windows
A user "Operator" with standard user rights is already created on the Windows system.
The user is in a user group "SIEMENS TIA Engineer". This grants the user the rights to use
the installed SIMATIC software products.
To use the CPU 1515SP PC2 directly, the Windows "Autologon" function is enabled for the
"Operator" user. No password is preset.
Note
When you assign a password, change the ent
ry for the "Autologon" function accordingly
using the Windows user administration.
To Next Page
Loading...
Need help?
General
