Siemens SIMATIC CPU 1515SP PC2 F - Switching the Open Controller On;Off

Commissioning
8.3 Initial commissioning an open controller
CPU 1515SP PC2 (F/T/TF)
50 Operating Instructions, 09/2018, A5E42603425-AA
8.3.7
Switching the Open Controller on/off
Requirements
Initial commissioning was successfully completed.
Switching on the CPU 1515SP PC2
Proceed as follows to switch on the CPU 1515SP PC2:
1. Switch on the power supply of the CPU.
The Boot Manager GRUB2DOS starts.
2. Select the mode in which the CPU 1515SP PC2 should start:
– Default: with the Windows operating system and the S7-1500 software controller
– Only with the Windows operating system (e.g. with updates)
Switching off the CPU 1515SP PC2
Proceed as follows to switch off the CPU 1515SP PC2:
1. Use the Windows function
Start > Power > Shut down
to switch off.
The PWR LED changes from green to yellow.
The Windows function shuts down the Windows operating system and the S7-1500
software controller.
If the device will not be used for a longer period after the shutdown, de-energize the device.