Commissioning the
7.1 Basics
F-TM ServoDrive
Equipment Manual, 02/2020, A5E47579503-AA
55
7.1 Basics
7.1.1 Engineering
You perform configuration as well as diagnostics of a F-TM ServoDrive ST with a PG/PC or
notebook (commissioning device) using the TIA Portal (Hardware Support Package
HSP0311 needed).
The settings can be found in STEP 7 in the device navigation under "Ungrouped devices" >
"<Name of the interface module>" > "<Name of the F-TM ServoDrive>".
Overview
This drive engineering is divided into the following areas:
● Online & diagnostics
● Parameters
● Device configuration
"Device configuration" area
Contents in the "Device configuration" area of the F-TM ServoDrive engineering.
● Potential group
● Basic parameters
Define telegram, activate telegram extension
● I/O addresses
"Online & diagnostics" area
Contents in the "Online & diagnostics" area of the F-TM ServoDrive engineering.
Diagnostics
● General (module information):
Order number, firmware and hardware version, I&M data
● Diagnostic status (display of status information)
● Active messages:
Pending faults and alarms
● Drive diagnostics
Status bits, operating values, encoders, temperatures, inputs
Functions
● Firmware update
To Next Page
Loading...
