Starting up
7-3
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
7.2 Initial values for testing and optimization
Parameterization information
You can find information about parameterization:
S In Chapter 5 of this manual
S In the on-line help in “Parameterize FM 353”
Overview
The following overview display appears in the “Parameterize FM 353” tool:
Fig. 7-1 Overview display for parameterization and start-up
You can return to this display at any point during parameterization by selecting the
menu View > Overview.
As it is written to the FM 353, the DB-MD is checked for the input limits of the indi-
vidual values and their interdependencies. It is then stored only if all values are
allowed. Otherwise data error messages are displayed by way of the MPI. A defec-
tive DB will not be retained when the power is turned off.
To Next Page
Loading...
