Configuring
5.3 Configuration via XML
SIMATIC RF360R
32 Configuration Manual, 03/2022, C79000-G8976-C629-02
5.3 Configuration via XML
This section is intended only for XML users.
Configuration of the reader is not necessary for pure XML work. You can continue directly
with configuration via WBM and with programming via XML. You can find detailed
information on this in the manual "XML programming for SIMATIC Ident
(https://support.industry.siemens.com/cs/ww/en/view/109781631)".
5.4 Configuration via OPC UA
This section is intended only for OPC UA users.
Configuration of the reader is not necessary for pure OPC UA work. You can continue directly
with configuration via WBM and with programming via OPC UA. You can find detailed
information on this in the manual "OPC UA for SIMATIC Ident
(https://support.industry.siemens.com/cs/ww/en/ps/14971/man)".
5.5 Configuring with Studio 5000 Logix Designer
This section is intended only for users of Rockwell controllers.
You can configure the reader using add-on instructions via a Rockwell controller. You can find
a detailed description of the Ident profile and the add-on instructions in the "Ident profile,
add-on instructions for Rockwell systems
(https://support.industry.siemens.com/cs/ww/en/view/109781634/137304404619)" function
manual.
Note
Serial number in Studio 5000 Logix Designer
Note that the serial number specified in the Studio 5000 Logix Designer does not match the
reader serial number. The serial number specified in the Logix Designer forms the last 4 bytes
of the MAC address of the reader.
described in this section was tested with the programs "Studio 5000 Logix
Designer" (V21 to V28) and "RSLogix 5000" (V20).
To Next Page