Siemens SIMATIC Ident RF360R - The Settings - Communication Menu Item

Configuring with the WBM
6.3 The menu items of the WBM
SIMATIC RF360R
46 Configuration Manual, 03/2022, C79000-G8976-C629-02
The "Transponder type" parameter
Selection of the transponders used. The following transponder types can be selected:
Reader parameter assignment
Values
RF300
None
RF300
ISO 15693
None
General
MDS D1xx, NXP
MDS D2xx, TI
MDS D3xx, Infineon
MDS D4xx, Fujitsu - 2 KB
MDS D5xx, Fujitsu - 8 KB
6.3.4 The "Settings - Communication" menu item
The "Settings - Communication" menu item is divided into the following tabs.
• Network interfaces
• PLC
• XML
• OPC UA
In the "Network interfaces" tab, you can enable/disable the network ports, SNMP and NTP
protocols. You can block PLC access in the "PLC" tab. In the "XML" tab, you can specify which
data is sent via the XML interface. In the "OPC UA" tab, you can enable and edit the OPC UA
server function of the reader.
The "Network interfaces" tab
The "Network interfaces" tab is divided into the following areas:
• Network basic settings
• SNMP
• NTP
• Syslog messages