Service and maintenance
8.1 Diagnostics
SIMATIC RF360R
Configuration Manual, 03/2022, C79000-G8976-C629-02
79
• SNMPv2.mib
• SNMPv2Smi.mib
You can find the MIB files corresponding to the communications modules on the pages of
Siemens Industry Online Support
(https://support.industry.siemens.com/cs/ww/en/view/67637278) (automation MIBs) or on
the pages of the PROFINET user organization (https://www.profibus.com/download/profinet-
specification/) (LLDP MIBs).
The readers support the SNMPv1 protocol. SNMP is activated at the factory. You can find
information on SNMP in the section "The "Settings - Communication" menu item (Page 46)".
You can find detailed information on using SNMP and, in particular, on the structure of the
automation.mib in the diagnostics manual "Network management diagnostics and
configuration with SNMP (https://support.industry.siemens.com/cs/ww/en/view/103949062)".
8.1.3 Diagnostics using the WBM
A wide variety of diagnostics options are available via the WBM.
In the "Log" menu, you will find all the diagnostic messages of the reader that have occurred.
The "Service log" helps SIEMENS specialists to analyze errors. You can read out the syslog
messages from the "Syslog log" and you can read out the "Status parameters" of the reader
and transponders using the "Hardware diagnostics".
You will find further information on the "Log" in the section "The "Diagnostics - Log" menu
item (Page 60)".
8.1.4 Diagnostics using the TIA Portal (STEP 7 Basic / Professional)
This section is intended only for S7 users.
Requirements
STEP 7 Basic / Professional is installed and started, and a project is open. The reader is
connected to the controller or PC via Industrial Ethernet or PROFINET and has been powered
up.
To Next Page