Service and maintenance
8.2 Error messages
SIMATIC RF360R
84 Configuration Manual, 03/2022, C79000-G8976-C629-02
Flashin
g of the
reader
Block (hex) Error description
Transponder is unable to execute the initialization command
Possible causes:
• Transponder is defective.
The transponder memory is full.
RF300: Data storage was not completed correctly for the semaphore procedure.
The command is not supported by the transponder.
The transponder is read/write-protected.
The transponder is not responding.
The transponder password is incorrect. Access is denied.
The verification of the written transponder data has failed.
Possible causes:
• Transponder is defective.
Transponder is in the limit area.
General transponder error
The transponder has too little power to execute the command.
Possible causes:
• Transponder is in the limit area.
To Next Page