Maintaining and repairing the device
6.4 Installing the software
SIMATIC IPC227E
Operating Instructions, 11/2016, A5E35782395-AB
79
Note
If you want to install the operating system on a data carrier connected to a data carrier
controller unknown to the operating system, you have to integrate the driver
of the data
carrier controller. Integrate this driver before starting the partitioning of the data carrier and
installing the operating system, see Section "Information for systems with data carrier
controller".
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies, depending on the operating
system, how much RAM you have available and how much additional software you want
to use. Information on how the data carrier is partitioned in its factory state is available in
the following tables.
2. Select the partition on which you want to install the operating system.
3. Click "Next".
Installation is started.
Examples of partitions in the factory state
Windows 7 32 bit:
Information for systems with data carrier controller
Data carrier controllers unknown to the operating system must be made known to the
operating system prior to installation in the "Install Windows" installation program.
You have copied the relevant controller driver to a USB stick.
1. Connect the USB stick with the controller driver to the device.
2. Start the "Install Windows" installation program as described above.
3. Select "Load Drivers" in the Windows installation window.
4. Select the respective driver on the USB stick.
To Next Page
Loading...
Need help?
General
