Initial startup
3.4 Pre-configurations
SIMATIC IPC427C Bundles, SIMATIC HMI IPC477C Bundles
Manual, 07/2009, A5E02280126-02
19
3.4.2 Pre-configured -HMI PROFINET/PROFIBUS (PN/DP)
The -HMI PN/DP software package includes the Windows Embedded operating system,
WinCC flexible RT as well as integrated CP 5611 and Industrial Ethernet communication
interfaces. All software is pre-installed on your hardware platform and pre-configured.
You do not have to perform any additional installation or configuration; however, you can use
the SIMATIC PC Wizard to adjust your PC display preferences.
-HMI configuration
The -HMI PN/DP software package does not include a PC Station configuration. You transfer
WinCC flexible projects directly from the engineering station to WinCC flexible RT on the
hardware platform. You can perform transfers over the following channels:
● Default:
– Serial
– Industrial Ethernet
● Optionally configurable:
– MPI
– USB
You can connect other devices such as a mouse, keyboard, or storage device to the
hardware platform via the USB ports. To use the restore DVD (Page 41), you need a
USB DVD-ROM dri
ve. You do not ne
ed these USB devices for general operation.
The hardware platform uses a CompactFlash card for data storage. Typically, you use the
Enhanced Write Filter (EWF) to protect the C:\ drive of the CompactFlash card; however,
you must take care to manage the EWF (Page 35) if you use the C:\ drive for any file
storage. For WinCC flexible RT, a D:\ drive on the
CompactFlash card with the EWF
disabled is recommended.
In addition to this documentation, you can find technical specifications and other information
in the SIMATIC Embedded Bundles product documentation. Refer to the Introduction
(Page 5) for a summary of other docume
n
tation that may be u
s
eful.
To Next Page
Loading...
