SIMATIC IPC427C Bundles, SIMATIC HMI IPC477C Bundles
Manual, 07/2009, A5E02280126-02
25
User tasks
4
4.1 Overview
This section covers the following topics:
● "Creating the STEP 7 project and config
uring the hardware" (Pa
ge 26):
This topic describes how to create a project, add a PC Station (-RTX/RTX F) or
HMI Station (-HMI/RTX) to it, and configure the hardware configuration to correspond to
the default configuration of the SIMATIC Embedded Bundle.
● "Configuring the Windows Ethernet Interfac
e" (Page 29): This topic expl
ains the locations
of the Ethernet connections and how to configure the IP addresses for these connections.
● "Configuring the WinCC flexible Project" (Page 31): You must configure your
WinCC flexible project with the WinCC flexible ES (en
gineering station) software, and
transfer this project from the engineering station computer to WinCC flexible RT on the
SIMATIC Embedded Bundle. This topic describes how to change the WinCC flexible RT
settings on the SIMATIC Embedded Bundle after this transfer is complete.
● "Downloading PC Station compon
ents" (Page 32): This
topic
ex
plains what to do if you
need to change and download the configuration of the PC Station (for example, if you
want to add WinCC flexible to the configuration, or if you want to download the
OPC Server configuration).
● "Managing the Enhanced Write Filter" (Page 35): The Enhanced Write Filter (EWF) is a
Windows Embedded utility for protecting
a CompactFlash card. CompactFlash cards
allow a limited number of write accesses. This topic describes how to use the
EWF manager.
● "Creating a System Image" (Page 37): After you have configured the
SIMATIC Embedded Bundle for your ap
plication, you can create an image of your
system. If necessary, you can use this image later to restore your custom application to
your system. This topic explains how to perform this task.
To Next Page
Loading...
Need help?
General
