Siemens SIMATIC IPC477E User Manual

Maintaining and servicing your device
7.5 Installing the software
SIMATIC IPC477E
106 Operating Instructions, 12/2016, A5E37455003-AB
7.5.2.2
Partitioning in Windows 7 Ultimate
You will need to reconfigure the partitions after installing a new drive, to repair corrupt
partitions or to change the partitioning.
Partitioning of the HDD or SSD
In the factory state, the following partitions are set up on the HDD or SSD for the
Windows 7 x64 UEFI operating system:
Partition
Name
Partition size
File system
SSD: 80 GB
SSD/HDD: > 200 GB
First
Boot
260 MB
FAT32
Second
MSR
128 MB
None
Third System 60 GB 100 GB NTFS, not compressed
Fourth
Data
Remainder
NTFS, not compressed
7.5.2.3
Adapting partitions in Windows 7 Ultimate and Windows Embedded Standard 7
With the disk management, you can adapt the partitioning of your drives.
You can reduce or delete an available partition to acquire unassigned memory space, which
you can use to set up a new partition or to increase an existing partition.
Note
Data lost in the case of deleting a partition!
If you delete a partition, all the data on this partition is lost.
Back up your data before you change partitions.
Requirement
You are logged on as an administrator.
Procedure - Reduce partition
A partition can only be reduced if sufficient space is available.
1. Click with the right mouse button on the partition to be reduced and click on "Reduce
size".
2. Follow the instructions.

Siemens SIMATIC IPC477E Specifications

General

Brand	Siemens
Model	SIMATIC IPC477E
Category	Industrial PC
Language	English