Device maintenance and repair
7.5 Installing the software
SIMATIC IPC547E
Operating Instructions, 02/2014, A5E32317120-AB
103
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies depending on which operating
system, how much work memory and the additional software you want to use. Information
on how the disks are partitioned in the delivery state can be found in the table below.
2. Select the partition on which you want to install the operating system.
3. Click "Next".
Installation is started. The Windows operating system is installed on the data medium.
Partitions in delivery state for Windows 7 and Windows Server 2008 R2
The following information applies to data storage media ≥ 100 GB.
First BOOT 100 MB Automatically set up by
Information for systems with RAID or AHCI controller
Data carrier controllers unknown to the operating system must be made known to the
operating system prior to installation in the "Install Windows" installation program.
You have copied the relevant controller driver to a USB stick.
1. Connect the USB stick with the controller driver to the device.
2. Start the "Install Windows" installation program as described above.
3. Select "Load Drivers" in the Windows installation window.
4. Select the respective driver on the USB stick.
To Next Page
Loading...
Need help?
General
