Device maintenance and repair
7.4 Removing and installing hardware
SIMATIC IPC547E
94 Operating Instructions, 02/2014, A5E32317120-AB
Remove the cable ties securing the power
cables in the enclosure.
Disconnect the cables of the drives and the
motherboard.
Remove the highlighted screws.
Pull out the enclosure of the power supply
from the IPC housing from the back.
For installation, follow the steps for removal in reverse order.
Removing the motherboard
Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
device (Page 53)".
● The device is open, see the chapter "Open the device (Page 62)".
● A motherboard
The motherboard as spare part is supplied without processor and memory modules.
● T10 screwdriver
To Next Page
Loading...
