Siemens SIMATIC IPC547E - Connecting Peripheral Equipment

Installing and connecting the device
3.3 Connecting the device
SIMATIC IPC547E
Operating Instructions, 02/2014, A5E32317120-AB
43
To prevent unintentional removal of the power cable, you can secure the power plug as
follows:
1.
Remove the retaining screws
①
.
2.
Screw on the latch for the power plug ②.
3.3.4
Connecting peripheral equipment
Note
Observe suitability for industrial applications
Only connect I/O devices that are suitable for industrial applications in accordance with
EN
IEC 61000-6-2.
Note
I/O devices capable of hot-plugging (USB)
Hot
-plug I/O devices (USB) may be connected while the PC is in operation.
NOTICE
Non-hot-plug I/O devices
I/O devices that do not support hot-plugging may not be connected until the device is
powered off. Strictly adhere to the specifications for peripheral equipment.