SIMATIC Rack PC 840 Expansions
4-16
SIMATIC Rack PC 840 Manual
A5E00104826-03
4.5.4 Removal and Installation of the Floppy/CD ROM Drive
1. Open the housing as described in Section 4.1.
2. Remove the drive holder as described in Section 4.5.1.
3. Remove the data and power supply cables on the drive.
4. Undo the four screws on the drive and push the drive forward out of the holder.
5. Proceed in reverse order when installing the new drive.
Fixing screws of the floppy/
CD-ROM drive holder
Figure 4-11 Installation of the Floppy Disk/CD ROM Drive Holder
To Next Page
Loading...
