Configuring the SIMATIC Rack PC 840
5-26
SIMATIC Rack PC 840 Manual
A5E00104826-03
5.9 Default Setup Settings
Documenting Your Device Configuration
If you have made any modifications to the default Setup settings, you can enter
them in the following table. You can then refer to these entries if you need to make
any hardware modifications later.
Note
Print the following table out and keep the pages in a safe place once you have
filled in your entries.
System Parameter Default Settings Your Entries
Main
System Time hh:mm:ss
System Date MM/TT/JJJJ
Diskette A 1.44 MB, 3 1/2”
Primary Master
Primary Slave None
Secondary Master None
Secondary Slave None
Boot Options
Quick Boot Mode Enabled
SETUP prompt Enabled
POST Errors Enabled
Floppy check Disabled
Summary screen Enabled
Keyboard Features
Num Lock On
Key Click Disabled
Keyboard auto-repeat rate: 30/s
Keyboard auto-repeat delay 1/2s
Hardware Options
PCI-MPI/DP: Enabled
On Board Ethernet Enabled
Ethernet Adress 08000624xxxx
LAN Remote Boot Enabled
Legacy USB Support Disabled
SafeCard Functions Enabled
Fan Control Enabled
PS2 Mouse Auto
To Next Page
Loading...
