Siemens SIMATIC Rack PC 840 - The Advanced Menu

Configuring the SIMATIC Rack PC 840
5-12
SIMATIC Rack PC 840 Manual
A5E00104826-03
5.3 The Advanced Menu
Menu Structure
PhoenixBIOS Setup Utility
Item Specific Help
ESC Exit
Reset Configuration Data:
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
COM/LPT Configuration
Floppy disk controller: [Enabled]
[ No ]
Select the operating
system installed
on your system which
you will use most
commonly.
Note: An incorrect
setting can cause
some operating
systems to display
unexpected behavior.
Enter
Help
F1
Security Power Boot Sequence Version ExitMain
Large Disk Access Mode: [DOS]
Local Bus IDE adapter: [Primary & S]
Advanced
Memory Gap at 15 Mbyte: [Disabled]
Defaut Primary Video Adapter: [AGP]
Installed O/S:
[ Other ]
PCI Configuration
Setup Warning
Setting items on this menu to incorrect values may
cause your system to malfunction
Figure 5-8 ”Advanced” Menu
Setting in the Advanced Menu
Installed O/S Plug and Play means that all modules are automatically detected and
installed, providing they support the Plug and Play functionality.
[other] BIOS handles the entire Plug and Play capability, default
configuration
[Win95] BIOS handles the entire Plug and Play capability, default
configuration
[Win98] The operating system handles some of the Plug and Play
functions
[WinMe/2k The operating system handles the Plug and Play functions
Reset
Configuration
Data
[Yes] All installations under Plug and Play are deleted and
reconfiguration is triggered the next time the system boots.
The entry is then reset to [No]. System components that do
not support Plug and Play have to be entered manually.
Floppy disk
controller
[Enabled] The floppy disk controller is switched on.
[Disabled] The floppy disk controller is switched off.