Siemens SIMATIC Rack PC 840 - Page 80

Configuring the SIMATIC Rack PC 840
5-10
SIMATIC Rack PC 840 Manual
A5E00104826-03
Numlock Switches Numlock on or off following power on. If “Auto” is set,
this will be remembered the next time the device is switched on.
Key Click A keystroke can be heard
Keyboard auto-repeat
rate
Increase in automatic key repeat rate
”Hardware Options” Field
The following submenu appears when you select the “Hardware Options” field in
the main menu:
PhoenixBIOS Setup Utility
Item Specific Help
PCI – MPI / DP:
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
Enter
Help
F1
Main
[ Enabled ]
Hardware Options
Onboard Ethernet
[Enabled]
Enable or disable the
PCI - Multi Point
Interface (MPI/DP)
Ethernet Address
08000624xxxx
PS/2 Mouse:
[Enabled]
LAN Remote Boot: [Disabled]
SafeCard functions:
[Enabled]
Fan Control:
[Enabled]
1)
Figure 5-7 ”Hardware Options” Submenu
The parameters of the interfaces present on the motherboard are set here.
Entry Meaning
PCI-MPI/DP *
1
Enables the CP5611-compatible MPI/DP interface. The resourses are
managed by the BIOS PCI Plug and Play mechanism.
On Board
Ethernet
[Enabled] The Ethernet port on the motherboard is enabled.
[Disabled] The Ethernet port on the motherboard is disabled.
Ethernet
Address
The individual Ethernet address is entered here.
*
1
Optional product feature