System Startup S5-115F Manual
4.1.7 Steps for System Startup
The following pages contain flowcharts, which will help you in starting up your S5-115F.
Figure 4-8. Flowchart for Startup: Overview (Main Tree)
yes
yes
yes
yes
no
Are the jumper settings on
the parallel link modules
correct?
STARTUP
Insert and wire modules
Power up PLC
Are the subunit IDs available?
Have the
operating system
configurations (DB 1) and
the I/O configurations
been loaded into
the PLC?
Is the user program in
the PLC?
Check the jumper settings on the
parallel link modules
( 3.2.6)
no
no
no
Enter subunit IDs
( Figure 4-9)
Load the operating system
configuration and the I/O
configuration ( Figure 4-10)
Transfer the user program
to the PLC
Label 1
Label 2
PLC in RUN mode
4-14
EWA 4NEB 811 6148-02
To Next Page
Loading...
Need help?
General
