Siemens SIMATIC S7 FH - Page 29

Product Overview
Fail-Safe Systems
A5E00085588-03
1-13
Software Requirements
The following software packages must be installed on the PC/programming device
in order to use, modify, or create projects based on Failsafe Blocks (V1_1) library
with S7 F Systems V5.2:
• S7 F Systems V5.2
• STEP 7 V5.1.3 or higher
• CFC V5.2.4
• S7 H Systems Optional Package V5.1or higher (required for S7 FH Systems)
Procedure
If S7 F Systems V5.1 is already installed, the projects based on Failsafe Blocks
(V1_1) library are supported without any additional procedures.
1.b. Installing S7 F Systems V5.2 on a New PC to Support Failsafe Blocks (V1_1)
Projects
Use this scenario if you have:
Purchased a new PC/Programming Device/Workstation, and you wish to use
projects based on Failsafe Blocks (V1_1) library.
Software Requirements
The following software packages must be installed on the PC/programming device
in order to use, modify, or create projects based on Failsafe Blocks (V1_1) library
with S7 F Systems V5.2:
• S7 F Systems V5.2
• STEP 7 V5.1.3 or higher
• CFC V5.2.4
• S7 H Systems Optional Package V5.1or higher (required for S7 FH Systems)
Procedure
1. If S7 F Systems V5.2 is installed, uninstall it.
2. Install S7 F Systems V5.1
3. Install S7 F Systems V5.2
4. If you had PCS7 Driver Blocks or PCS7 Library installed, you must also install
these.