Advantages/benefits/configuration with SIMOCODE pro
2.3 Simplifying configuration with SIMOCODE pro
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
33
2.3 Simplifying configuration with SIMOCODE pro
Conventional configuration without SIMOCODE pro
Individual components are used for control, monitoring and signal pre-processing. The
component and wiring requirements for this type of configuration are as follows:
● Use and wiring of overload relays, thermistor evaluation devices, current transformers
and analog/digital converters
● Wiring of the control circuit
● Connection of start / stop control devices
● The contactor must be brought into locking mode via the auxiliary switches
● Wiring of the interlocks
The following figure illustrates the conventional configuration of a direct starter:
Figure 2-3 Conventional configuration of a motor feeder (direct starter)
To Next Page
Loading...
