Siemens SIMOCODE pro Manual

Planning/Configuring
6.6 Configuring the DM-F PROFIsafe and integrating it into the fail-safe automation system using PROFIBUS/
PROFIsafe or PROFINET/PROFIsafe
SIMOCODE pro - Fail-Safe Digital Modules
Manual, 11/2017, NEB631679702000/RS-AA/002
49
To store the set PROFIsafe address:
The set PROFIsafe address is stored after switching on the power supply.
● Briefly press the SET / RESET button: LEDs 1 to 10 indicate the current PROFIsafe
address.
Figure 6-4 SET / RESET button
NOTICE
PROFIsafe address
The PROFIsafe address 1023 is set in the delivery state.
You must set a valid address in the range from 0 to 1022.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000