To Next Page

To Previous Page

Assembly

Observe the following when carrying out any work on the machine:

● Comply with the general safety instructions (Page 13)

● Comply with the applicable national and sector-specific regulations.

● When using the machine within the European Union, comply with the specifications laid

down in EN 50110‑1 regarding safe operation of electrical equipment.

Loss of conformity with European directives

In the delivery state, the machine corresponds to the requirements of the European directives.

Unauthorized changes or modifications to the machine lead to the loss of conformity with

European directives and the loss of warranty.

5.1 Preparations for installation

5.1.1 Requirements for installation

The following requirements must be satisfied prior to starting installation work:

● Staff have access to the relevant installation instructions and operating instructions.

● The machine is unpacked and ready for mounting at the installation location.

Note

Further Information

Further machine-specific information for installation can be found in Chapter "Technical

data and drawings" (Page 123).

Note

Measure the insulation resistance of the winding before starting installation work

Measure the insulation resistance of the winding before starting any installation work. If the

insulation resistance lies below the specified value, take appropriate remedial measures.

These remedial measures may necessitate the machine being removed again and

transported.

Siemens SIMOTICS HV M User Manual

Questions and Answers: