Siemens SIMOTICS HV M - Connecting the supply lines

See also
Service and Support (Page 121)
5.4 Connecting the supply lines
5.4.1 Surfaces for mounted parts or cable fixing elements
The surfaces on the enclosure are marked to which you can attach components or cables.
If you drill through the side panel, then seal the holes so that they are airtight.
'(6HLWH1'(6HLWH
$FKVK¸KH
$$
$
$
7
+
Figure 5-3 Areas for mounting parts
Shaft height Height H Panel/wall thickness T
800 1065 15
710 910 12
630 760 10
5.4.2 Connecting the cooling water supply
Documentation
Please refer to the operating instructions provided by the manufacturer of the heat exchanger
in Chapter "Additional documents (Page 129)". For the operating data of the air-to-water heat
exchanger, refer to the rating plate on the machine or the information about the dimension
drawing in the appendix.
Assembly
5.4 Connecting the supply lines
SIMOTICS HV M 1RN76308PR900CG0-Z
Operating Instructions 07/2018 55