Maintenance
9.3 Corrective maintenance
1LA5/6/7/9, 1LG4/6, 1MA6/7, 1MB..1/2/3/4/5 - SH 63 ... 355
Operating Instructions, 06/2018, A5E44455710A
129
Fitting bearings
Sealing the bearings
Note the following details:
● Shaft sealing rings are used to seal machines at the rotor shaft.
– For V rings, comply with the assembly dimension.
● Use the specified bearings.
● Ensure that the bearing sealing disks are in the correct position.
● Insert the elements for bearing preloading at the correct end.
● Fixed bearings can have a locking ring or bearing cover.
● Seal the bearing cap screws with the appropriate gaskets or with grease.
● Do not interchange the position of the bearing covers (DE and NDE or inner and outer).
If the motor is in a vertical position, the rotor can fall out while work is being performed on
the locating bearing. This can result in death, serious injury or damage.
• Support or unload the rotor when carrying out work with the machine in a vertical
position.
Bearing seals for explosion-protected machines
Note
Bearing seals for explosion-protected machines
For explosion
-protected machines, only use the original replacement and repair parts.
Fitting the bearing cartridges
When fitting the bearing cartridges, observe the specified screw tightening torques
(Page 133).
To Next Page
Loading...
