1LA5/6/7/9, 1LG4/6, 1MA6/7, 1MB..1/2/3/4/5 - SH 63 ... 355
Operating Instructions, 06/2018, A5E44455710A
51
Observe the following when carrying out any work on the machine:
● Comply with the general safety instructions (Page 11)
● Comply with the applicable national and sector-specific regulations.
● When using the machine within the European Union, comply with the specifications laid
down in EN 50110-1 regarding safe operation of electrical equipment.
Loss of conformity with European directives
In the delivery state, the machine corresponds to the requirements of the European
directives. Unauthorized changes or modifications to the machine lead to the loss of
conformity with European directives and the loss of warranty.
Explosion hazard when making modifications to the machine
Substantial modifications to the machine are not permitted – or may only be performed by
the manufacturer. Otherwise an explosion can occur in an explosive atmosphere. This can
result in death, serious injury or material damage.
● If necessary, please contact the service center.
Preparing for installation
5.1.1
Requirements for installation
The following requirements must be satisfied prior to starting installation work:
● Staff have access to the operating and installation instructions.
● The machine is unpacked and ready for mounting at the installation location.
Note
Measure the insulation resistance of the winding before starting installation work
Measure the insulation resistance of the winding before starting any in
stallation work. If
the insulation resistance lies below the specified value, take appropriate remedial
measures. These remedial measures may necessitate the machine being removed again
and transported.
To Next Page
Loading...
