Siemens SINAMICS G110

04/2005 Commissioning
SINAMICS G110 Operating Instructions
6SL3298-0AA11-0BP0
33
3.2 Commission Modes
Basic commissioning of the SINAMICS G110 Inverter can be performed by using
one of the following methods which are suitable for a large range of applications:
¾ Using the inverter with its factory default settings by connecting analogue and
digital inputs or using the RS485 connections (see Section 3.3.1 on page 35).
¾ Using the optional Basic Operator Panel (BOP) (see Section 3.3.2. on page 37).
Advanced commissioning allows the user to suitably adapt the inverter to the
specific application. Section 3.4 contains information about:
¾ Using a PLC to communicate with the inverter via the USS protocol (see
Section 3.4.1 on page 42).
¾ Using the PC Tool “STARTER” which communicates with the inverter via USS
protocol (see Section 3.4.1 on page 43).
¾ Optimal configuration of the inverter by setting parameters using ‘Quick
Commissioning’ (see Section 3.4.4 on page 46).
¾ Resetting inverter parameters to factory default (see Section 3.4.5 on page
49).
¾ Connecting a PTC temperature sensor to the inverter (see Section 3.4.6 on
page 49).
¾ Parameter Cloning with the BOP (see Section 3.4.7 on page 49).
Notes
When utilizing USS communications, a common 0 V reference connection is
required between all devices on the USS bus. Terminal 10 on the control board can
be used for this purpose.
The SINAMICS G110 inverter is available as two variants:
1. Analog Variant
The analog variant is suited to stand-alone applications. This variant is
designed to be controlled using external switches and a potentiometer
utilizing the analog input and digital inputs. Switches and potentiometers
are not provided as standard with the inverter.
2. USS Variant
The USS variant is suited to inverter networks. This variant is designed to
be controlled utilizing the USS protocol via the RS485 communications
interface. A number of inverters can then be connected and controlled via
the same communications bus.
The variant can be identified by reading the MLFB from the rating label and
comparing it to the MLFBs listed in Table 7-4 and Table 7-5 on pages 68 and 69
respectively.
Since the SINAMICS G110 is available in two variants; different options for the
commissioning of the inverters are available to the user. These commissioning
options are described in the following sections covering the ‘Basic Commissioning’
and ‘Advanced Commissioning’.