Siemens SINAMICS G110

Commissioning 04/2005
SINAMICS G110 Operating Instructions
38 6SL3298-0AA11-0BP0
Changing parameters with the Basic Operator Panel
The description below serves as an example that shows how to change any
parameters using the BOP. These examples can also be used as a guide to
configuring the inverter for running via the BOP (start/stop commands and the
frequency setpoint are input on the BOP).
Changing P0003 – parameter access level
Step Result on display
1
Press to access parameters
2
Press until P0003 is displayed
3
Press to display the parameter value
4
Press or
to set the required value
(set to 3)
5
Press to confirm and store the value
6
All level 1 to level 3 parameters are now
visible to the user.
Changing P0719 an indexed parameter – setting BOP control
Step Result on display
1
Press to access parameters
2
Press until P0719 is displayed
3
Press to access the parameter value
4
Press or
to select index 1
5
Press to display actual set value
6
Press or
to the required value
7
Press to confirm and store the value
8
Press
until r0000 is displayed
9
Press to return the display to the
standard drive display (as defined by the
customer)
Figure 3-5 Changing parameters via the BOP