Introduction
1.3 Overview of documentation
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
13
1.3 Overview of documentation
Manuals and software are available for every inverter application:
Table 1- 1 Documentation for SINAMICS G120
Planning and configuring Installation and
connection
Commissioning Service and maintenance
SIZER
engineering tool
--- --- ---
Configuration Manual
Selecting geared motors,
motors and inverters
using calculation
examples
--- --- ---
Hardware Installation Manual, Power Modules
Comprehensive information on every Power
Module. Available for:
● PM230
● PM240
● PM250
● PM260
--- Hardware Installation Manual,
Power Modules
(refer to the lefthand column)
Function Manual, Safety Integrated
Comprehensive information about the integrated safety functions of the CU240E-2 Control Unit
Operating instructions
Contains extensive information for most applications. Available for the following Control Units:
● CU230P-2
● CU240B-2 and CU240E-2
● CU240E and CU240S
--- --- STARTER
Commissioning tool
Getting Started
For entry level personnel to switch on the motor for the first time.
Available for Control Units:
● CU230P-2
● CU240B-2 and CU240E-2
● CU240E
● CU240S
---
--- --- Parameter Manual
Contains detailed lists of all parameters, alarms and faults as well as
graphic function block diagrams. Available for the following Control
Units:
● CU230P-2
● CU240B-2 and CU240E-2
● CU240E and CU240S
To Next Page
Loading...
