Siemens SINAMICS G120 - Set Reference Point

You have now de󹪝ned the analog signals for controlling.
❒
Parameter Meaning
p2595 Start referencing
p2598 Reference point coordinate, signal source
p2599 Reference point coordinate value
p2601 Flying referencing, inner window
p2602 Flying referencing, outer window
p2603 Flying referencing, relative positioning mode
p2612 Reference point approach, reference cam
r2684.11 Reference point set
p2660 Measured value referencing
6.6.4 Set reference point
Description
Position the load, e.g. using the "jog" function, at the reference position in the machine.
5HIHUHQFHSRLQWVHW
6HWUHIHUHQFHSRLQW
5HIHUHQFHSRLQWFRRUGLQDWH
W
V
W
V
Figure 6-14 Set reference point
Activate 'set home position'
Requirement
You have selected the "Homing" screen.
Commissioning
6.6 Referencing
Basic positioner
Function Manual, 09/2020, FW V4.7 SP13, A5E34257659B AG 67