Installing/mounting
4.4 Mounting the Power Modules
Power Module PM240-2
32 Hardware Installation Manual, 01/2017, A5E33294624B AE
Additional for Power Modules with push-through technology - PT devices
Use the optional mounting frames to mount a Power Module in push-through technology in a
control cabinet. The mounting frames include the necessary seals and frames to ensure
compliance with degree of protection IP55.
If you do not use the optional mounting frames, then you must ensure that the required
degree of protection is complied with using other appropriate measures.
Mounting instructions are provided in the following section:
Mounting frames for PT power modules (Page 107)
To Next Page
Loading...
