Siemens SINAMICS PM240-2 - STO via Power Module terminals

Power Module PM240-2
Hardware Installation Manual, 01/2017, A5E33294624B AE
65
Technical data
7
Power loss of the Power Modules
Note
Power loss for the FSA … FSC Power Modules
The values specified for the power loss are typical values at 100% of the rate
d speed and
100% of the load corresponding to Low Overload.
Power loss for the FSD … FSF Power Modules
The values specified for the power loss are typical values at 90% of the rated speed and
100% of the load corresponding to Low Overload.
Protective organs for the Power Module
The fuses listed in the following tables are examples of suitable fuses.
Additional components for branch protection are available in the Internet:
Branch protection and short-circuit strength according to UL and IEC
(https://support.industry.siemens.com/cs/ww/en/view/109486009)
7.1
Electromagnetic compatibility - Overview
Electromagnetic compatibility according to EN61800-3
Property
Version
Interference immunity
The inverters are suitable for use in the first and second industrial environments
Interference emission -
second environment
Category C2
for inverters with integrated radio interference suppression filter
Category C2 for inverters without fi
lter with optional external radio interference suppression
filter for grounded line supplies (recommended for operation in conjunction
with a residual current protective device RCD)
Category C3 for 690V inverters with integrated radio interference suppression filter, frame
size FSF
Category C4 for inverters without integrated radio interference suppression filter for opera-
tion on IT line supplies
Additional information as well as conditions for using the inverter in the first environment are
provided in the following Section:
Electromagnetic compatibility of variable-speed drives (Page 96).