Siemens SINAMICS S120 - 3 Configuration; Configuring Steps; Procedure for the Electrical Configuring

Hydraulic Drive
System Manual, 04/2015, 6SL3097-4BA00-0BP1
35
Configuration
3
3.1
Configuring steps
3.1.1
Procedure for the electrical configuring
The procedure for configuring an HLA is divided into steps in such a way that the user is
guided through the full range of relevant settings, from the required force, to the hydraulic
components, and finally the HLA and its sensor evaluation functions. This initial configuring
phase may be followed by a second in some cases, in which the corresponding circuit
recommendations and EMC measures are taken into account.
The functions of SINAMICS components are described with keywords in this manual. Limit
values for functions may be specified in some cases.
Please refer to the SINAMICS S120 and SINUMERIK 840Dsl commissioning instructions for
additional details (e.g. characteristics).
Phase 1
1. Selecting the hydraulic components
2. Selecting and dimensioning the power supply
3. Selecting and dimensioning the closed-loop control components
4. Selecting and dimensioning the position sensing (measuring system)
Phase 2
1. Circuit recommendations relating to EMC measures
2. Block diagrams/connection diagrams
3. Abbreviations, terms and index