Commissioning
4.17 Editing the valve characteristic
Hydraulic Drive
84 System Manual, 04/2015, 6SL3097-4BA00-0BP1
3. After you have completed the measurement, go to the "Tuning" dialog by pressing the
"OK" softkey:
Figure 4-26 Tuning the characteristic
4. Optional step
Adapt the set characteristic to the measured characteristic using an optimization
algorithm by pressing the "Tune valve characteristic" softkey.
5. Press the "OK" softkey to accept the characteristic.
A detailed description of the individual steps is given in the following chapters.
To Next Page
Loading...
