Siemens SINAMICS V20

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
208 Operating Instructions, 10/2019, A5E34559884-012
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data set
Data
type
Acc.
Level
r0094
CO: Transformation
angle [°]
- 0.0 - 4000H - Float 3
Displays the transformation angle (flux angle in VC mode or angle from frequency in Vf mode).
P0095[0...9]
CI: Display PZD signals
0 - 4294967295
0
T
4000H
-
U32
3
Selects source of display for PZD signals.
Index:
[0]
1st PZD signal
[1]
2nd PZD signal
...
...
[9]
10th PZD signal
r0096[0...9]
PZD signals [%]
-
-
-
-
-
Float
3
Displays PZD signals.
Index:
[0]
1st PZD signal
[1]
2nd PZD signal
...
...
[9]
10th PZD signal
Note:
r0096 = 100 % corresponds to 4000 hex.
P0100
Europe/North America
0 - 2
0
C(1)
-
-
U16
1
Determines whether the power settings are expressed in [kW] or [hp] (e.g. Rated motor power P0307).
The default settings for the rated motor frequency P0310 and maximum frequency P1082 are set automat-
ically here, in addition to reference frequency P2000.
0
Europe [kW], motor base frequency is 50 Hz
1
North America [hp], motor base frequency is 60 Hz
2
North America [kW], motor base frequency is 60 Hz
Dependency:
Where:
• Stop converter first (i.e. disable all pulses) before you change this parameter.
• P0100 can only be changed with P0010 = 1 (Commissioning mode) via the respective interface (for
example, USS).
• Changing P0100 resets all rated motor parameters as well as other parameters that depend on the
rated motor parameters (see P0340 - calculation of motor parameters).
r0191[0...2]
Configuration converter
-
0
-
-
-
U32
4
Displays the actual hardware configuration (SZL vector) of the converter.
Index:
[0]
SZL vector of converter and power module
[1]
SZL vector of converter
[2]
SZL vector of power module