Siemens SINAMICS V20

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
238 Operating Instructions, 10/2019, A5E34559884-012
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data
set
Data
type
Acc.
Level
P0881[0...2]
BI: Quick stop source 1
0 - 4294967295
1
T
-
CDS
U32
3
Allows quick stop source 1 command to be selected using BICO. The signal is expected to be active low
(default setting P0886 = 2).
Setting:
See P0810
P0882[0...2]
BI: Quick stop source 2
0 - 4294967295
1
T
-
CDS
U32
3
Allows quick stop source 2 command to be selected using BICO. The signal is expected to be active low
(default setting P0886 = 2).
Setting:
See P0810
P0883[0...2]
BI: Quick stop override
0 - 4294967295
0
T
-
CDS
U32
3
Allows quick stop override command source to be selected using BICO. The signal is expected to be
active high.
Setting:
See P0810
P0886[0...2]
Quick stop input type
0 - 4
2
T
-
CDS
U16
3
Control Word for selecting the quick stop input type.
0
Quick stop not selected
1
Quick stop input active high
2
Quick stop input active low
3
Quick stop input positive edge triggered
4
Quick stop input negative edge triggered
P0927
Parameter changeable
via specified interfaces
0 - 31 31 U, T - - U16 2
Specifies the interfaces which can be used to change parameters. This parameter allows the user to easi-
ly protect the converter from unauthorized modification of parameters.
Annotation: P0927 is not password protected.
Bit
Signal name
1 signal
0 signal
00
Not used
Yes
No
01
BOP (including built-in BOP and external BOP)
Yes
No
02
USS on RS232
Yes
No
03
USS on RS485
Yes
No
04
Script terminal on RS485
Yes
No
Example:
Default: All bits are set.
The default setting allows parameters to be changed via any interface.
r0944
Total number of mes-
sages
- - - - - U16 3
Displays the total number of messages available.