Siemens SINAMICS V20

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
245
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data
set
Data
type
Acc.
Level
3
Fixed frequency
5
USS/MODBUS on RS485
7
Analog setpoint 2
10 No main setpoint + MOP setpoint
11
MOP setpoint + MOP setpoint
12
Analog setpoint 1 + MOP setpoint
13
Fixed frequency + MOP setpoint
15
USS/MODBUS on RS485 + MOP setpoint
17
Analog setpoint 2 + MOP setpoint
20
No main setpoint + Analog setpoint 1
21
MOP setpoint + Analog setpoint 1
22
Analog setpoint 1 + Analog setpoint 1
23
Fixed frequency + Analog setpoint 1
25
USS/MODBUS on RS485 + Analog setpoint 1
27
Analog setpoint 2 + Analog setpoint 1
30
No main setpoint + Fixed frequency
31
MOP setpoint + Fixed frequency
32
Analog setpoint 1 + Fixed frequency
33
Fixed frequency + Fixed frequency
35
USS/MODBUS on RS485 + Fixed frequency
37
Analog setpoint 2 + Fixed frequency
50
No main setpoint + USS/MODBUS on RS485
51
MOP setpoint + USS/MODBUS on RS485
52
Analog setpoint 1 + USS/MODBUS on RS485
53
Fixed frequency + USS/MODBUS on RS485
55
USS/MODBUS on RS485 + USS/MODBUS on RS485
57
Analog setpoint 2 + USS/MODBUS on RS485
70
No main setpoint + Analog setpoint 2
71
MOP setpoint + Analog setpoint 2
72
Analog setpoint 1 + Analog setpoint 2
73
Fixed frequency + Analog setpoint 2
75
USS/MODBUS on RS485 + Analog setpoint 2
77
Analog setpoint 2 + Analog setpoint 2
Dependency:
Related parameter: P1074 (BI: Disable additional setpoint)
Caution:
Changing this parameter sets (to default) all settings on item selected. These are the following parame-
ters: P1070, P1071, P1075, P1076
If P1000 = 1 or 1X, and P1032 (inhibit reverse direction of MOP) = 1, then reverse motor direction will be
inhibited.
Note:
RS485 also supports MODBUS protocol as well as USS. All USS options on RS485 are also applicable to
MODBUS. To alter the setpoint using the BOP when the command source P0700 is not set to 1, you must
check that P1035 is set to r0019 bit 13 and P1036 is set to r0019 bit 14.