Siemens SINAMICS V20

Electrical installation
4.2 Terminal description
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
45
No.
Terminal
marking
Description
Digital inputs
*
8
9
10
11
12
DI1
DI2
DI3
DI4
DI C
Mode: PNP (reference terminal low)
NPN (reference terminal high)
Characteristics values are inverted for NPN
mode.
Isolation to control circuit:
Electrically isolated
Absolute maximum voltage:
± 35 V for 500 ms every 50 seconds
Operating voltage:
- 3 V to 30 V
Threshold 0 ⇒ 1 (maximum):
11 V
Threshold 1 ⇒ 0 (minimum):
5 V
Input current (guaranteed off):
0.6 mA to 2 mA
Input current (maximum on):
15 mA
2-wire Bero compatibility:
No
Response time:
4 ms ± 4 ms
Pulse train input:
No
13 24V 24 V output (tolerance: - 15 % to + 20 %) referred to 0 V, maximum 50 mA, non-
isolated
14
0V
Overall reference potential for digital inputs
Digital out-
puts (transis-
tor)
15
16
DO1 +
DO1 -
Mode:
Normally open voltage-free terminals, polarised
Isolation to control circuit:
500 VDC (functional low voltage)
Maximum voltage across termi-
nals:
± 35 V
Maximum load current:
100 mA
Response time:
4 ms ± 4 ms
Digital out-
puts (relay) *
17
18
19
DO2 NC
DO2 NO
DO2 C
Mode:
Change-over voltage-free terminals, unpolarised
Isolation to control circuit:
4 kV (230 V mains)
Maximum voltage across termi-
nals:
240 VAC/30 VDC + 10 %
Maximum load current: 0.5 A @ 250 VAC, resistive
0.5 A @ 30 VDC, resistive
Response time: Open: 7 ms ± 7 ms
Close: 10 ms ± 9 ms
* The optional I/O Extension Module provides additional DIs and DOs which share the same technical specifications as
those on the SINAMICS V20 converter.
WARNING
Risk of electric shock
The input and output terminals, numbered 1 to 16, are safety extra low voltage (SELV)
terminals and must only be connected to low voltage supplies.