Siemens SINEMA Remote Connect - Page 62

Configuring with Web Based Management
4.6 System
SINEMA Remote Connect - Server
62 Operating Instructions, 11/2017, C79000-G8976-C383-04
3. An entry between 10 and 30 is permitted. When the maximum number is reached, the
oldest backup copy is overwritten.
4. If the system should be backed up at regular intervals, specify the interval and the time
for the backup.
5. Enter a "coding key".
The coding key must be at least 8 characters long and contain special characters, upper
and lowercase characters as well as numbers, refer to the section "Permitted characters
(Page 21)".
6. Confirm the coding key.
7. Click the "Save" button.
Creating a new backup copy
Requirement
● The settings for the backup copies are configured.
With this function, you create a new backup copy with the current settings of the system.
1. Click the "Create new backup copy" button.
2. In the dialog that follows, if required enter a comment on the backup copy.
3. Click the "Finish" button.
Result
The backup copy is created and displayed in the list of backup copies.
Note
Settings that are not taken
The following settings are not backe
d up:
•
Network settings (exception: HTTPS port)
•
Logfile messages
Importing a file with a backup copy
Note
The coding key must be identical on both systems. A backup copy coded with the key (x)
cannot be imported on a system
with the key (y).
With this function, a previously created backup copy that was saved as a file is loaded.
1. Click the "Import backup copy" button.
2. In the dialog that follows, if required enter a comment on the backup copy.
3. Click the "Browse" button.