Configuring with Web Based Management
4.7 Remote connections
SINEMA Remote Connect - Server
Operating Instructions, 11/2017, C79000-G8976-C383-04
69
3.
Configuring the VPN connection mode
– Set the following parameters:
VPN protocol Specify which protocol will be used for the VPN connection.
1. OpenVPN: The connection will be established via OpenVPN.
You configure the settings in "Security > VPN basic settings >
OpenVPN".
2. IPsec: The connection will be established via IPsec.
IPsec profile Can only be selected in the "IPsec" connection mode. You config-
ure the IPsec profiles in "Security > VPN basic settings > IPsec
profile".
Request VPN address When enabled, a VPN address is requested during connection
establishment.
• OpenVPN: The setting is always enabled and cannot be modi-
fied.
• IPsec: Enable or disable the setting.
Use fixed VPN address When enabled you can assign the device a fixed VPN address. Via
the V
PN connection, the device can always be reached at this VPN
address.
This is only possible when the parameter "Activate fixed IP address
space" is enabled.
The parameter depends on the VPN connection mode.
• OpenVPN: Remote connections > Address spaces > OpenVPN
• IPsec: Remote connections > Address spaces > IPsec
OpenVPN connection
parameters
Can only be configured in the "OpenVPN" connection mode.
Only necessary when the WAN IP address of the SINEMA RC
Server is translated with NAT.
• IP address of the connection
Enter the IP address via which the SINEMA RC Server can be
reached.
• Connection port
Enter the port at which the SINEMA RC Server receives the
OpenVPN connection.
• IP protocol
Specify whether the OpenVPN connection goes via TCP or
UDP.
• Actions
To delete, click on in the actions.
To Next Page
Loading...
