Siemens SINEMA Remote Connect - Page 70

Configuring with Web Based Management
4.7 Remote connections
SINEMA Remote Connect - Server
70 Operating Instructions, 11/2017, C79000-G8976-C383-04
Field
Meaning
IPsec connection pa-
rameters
Can only be configured in the "IPsec" connection mode.
• Authentication:
– CA Cert: CA certificate
The certificate of the certification authority is used for au-
thentication. You specify the certificate in "Certificate".
• Certificate
Select the CA certificate for the IPsec connection. Only import-
ed certificates can be selected
• Local ID
Enter the local ID. Necessary when the VPN tunnel partner
evaluates the entry.
• Remote ID
Enter the ID of the VPN tunnel partner. Necessary when the
VPN tunnel partner evaluates the entry.
– Click the "Continue" button.
4.
Using the local subnet
– If the subnet downstream from the device also needs to be exported, enable the check
box "Connected local subnets".
– Enter the following connection parameters as well:
Box
Meaning
Local IP address IP address at which the device in the remote subnet can be
reached.
Network mask
The network mask of the remote subnet.
Device is a network
gateway
The device in the remote subnet is a network gateway.
When enabled, "Yes" is displayed for network gateway in the ta-
bles.
– Click the "Add" button. The IP address of the remote subnet is displayed in the table.
– To change an entry, you must first delete this entry and then create a new one. To
delete, click on
in the actions.