Technical Appendix
7-1 SINUMERIK 801
Start-Up
mm,
degrees
Fixed–value positions of axis with G75 (position no.) POWER ON
_always 0.0 – – DOUBLE
31000 ENC_IS_LINEAR
– Direct measuring system (linear scale) (encoder no.) POWER ON
_always 0 *** ***
BOOLEAN
31010 ENC_GRID_POINT_DIST
mm Division period for linear scales (encoder no.) POWER ON
_always 0.01 0.0 plus DOUBLE
31020 ENC_RESOL
– Encoder markings per revolution (encoder no.) POWER ON
_always 2048 0.0 plus DWORD
31030 LEADSCREW_PITCH
mm Pitch of leadscrew POWER ON
_always 10.0 0.0 plus DOUBLE
31040 ENC_IS_DIRECT
– Encoder mounted directly to the machine (encoder no:) POWER ON
_always 0 *** ***
BOOLEAN
31050 DRIVE_AX_RATIO_DENOM
– Denominator load gearbox (control parameter no.): 0 ... 5 POWER ON
_always 1, 1, 1, 1, 1, 1 1 2147000000 DWORD
31060 DRIVE_AX_RATIO_NUMERA
– Numerator load gearbox (control parameter set no.): 0 ...
5
POWER ON
_always 1, 1, 1, 1, 1, 1 1 2147000000 DWORD
31070 DRIVE_ENC_RATIO_DENOM
– Denominator resolver gearbox (encoder no.) POWER ON
_always 1 1 2147000000 DWORD
31080 DRIVE_ENC_RATIO_NUMERA
– Numerator resolver gearbox (encoder no.) POWER ON
_always 1 1 2147000000 DWORD
31090 JOG_INCR_WEIGHT
mm,
degrees
Evaluation of an increment with INC/handwheel RESET
31100 BERO_CYCLE
– Steps for monitoring rotation POWER ON
2000 10 10000000 DWORD
To Next Page
Loading...
