Siemens SINUMERIK 802C base line User Manual

Start-Up
4-36 SINUMERIK 802C base line
Start-Up
Number Explanation Default Value
32700 Interpolatory compensation (encoder no.): 0,1 0
33050 Traversing distance for lubrication from PLC 100 000 000
35010 Gear change possible. Spindle has several gear
steps
0
35040 Own spindle reset 0
35100 Maximum spindle speed 10000
35110 Maximum speed for gear change (gear stage
no.): 0..5
500,...
35120 Minimum speed for gear change (gear stage
no.): 0..5
50,...
35130 Maximum speed of gear stage (gear stage no.):
0...5
500,...
35140 Minimum speed of gearstage (gear stage no.):
0...5
5,...
35150 Spindle speed tolerance 0.1
35160 Spindle speed limitation from PLC 1000
35220 Speed for reduced acceleration 1.0
35230 Reduced acceleration 0.0
35300 Position control switch–on speed 500
35350 Direction of rotation when positioning 3
35400 Reciprocation speed 500
35410 Acceleration during reciprocating 16
35430 Starting direction during reciprocation 0
35440 Reciprocation time for M3 direction 1
35450 Reciprocation time for M4 direction 0,5
35510 Feedrate enable for spindle stopped 0
36000
(only
SPOS)
Exact positioning coarse 0.04
36010
(only
SPOS)
Exact positioning fine 0.01
36020
(only
SPOS)
Delay exact positioning fine 1
36030
(only
SPOS)
Zero–speed tolerance 0.2
36040
(only
SPOS)
Delay zero–speed monitoring 0.4
36050
(only
SPOS)
Clamping tolerance 0.5
36060
(only
SPOS)
Maximum velocity/speed ”axis/spindle stopped” 5 (axis);
0.0138
(spindle)
36200 Threshold value for velocity monitoring (control
parameter set no.): 0...5
11500 (axis);
31,94 (spindle)
36300 Encoder limit frequency 300000
36302 Encoder limit frequency at which encoder is
switched on again. (Hysteresis)
99.9

Siemens SINUMERIK 802C base line Specifications

General

Brand	Siemens
Model	SINUMERIK 802C base line
Category	Controller
Language	English