Siemens SINUMERIK 802C base line User Manual

Start-Up
SINUMERIK 802C base line
4-33
Start-Up
4.7 Commissioning
Initializing the control system
z
Turn on the control system.
z
The SINUMERIK 802C base line will load the standard machine data
automatically.
4.7.1 Entering the general machine data
Overview
To make your work easier, the most important machine data of the individual
subranges are listed. If more detailed information is required, the user is
referred to the relevant chapters/sections of this manual. The machine data
and interface signals are described in detail in the descriptions of functions to
which reference is made in the relevant lists.
Notice
The general machine data are selected such (default values) that only a few
machine data parameters have to be modified.
Entering the machine data (MD)
Before the machine data can be entered, the password for protection level 2 or
3 must be entered.
The following machine data ranges must be selected and modified (if
necessary) using the appropriate softkeys:
z
General machine data
z
Axis machine data
z
Other machine data
z
Display machine data
Once entered, these data are immediately written to the data memory.
The machine data are activated depending on the Activation setting of the
appropriate machine data, Section 4.1.2.
Notice
Since these data are only stored in the memory backed up for a limited period
of time, a data backup is necessary (see Section 4.1.4).
Machine data
The following machine data list contains all general and other machine data
and setting data, which can be changed if necessary.

Siemens SINUMERIK 802C base line Specifications

General

Brand	Siemens
Model	SINUMERIK 802C base line
Category	Controller
Language	English