Siemens SINUMERIK 804D sl Programming Manual

TMOF, 974
TMON, 974
TOFF, 84
TOFFL, 84
TOFFLR, 84
TOFFOF, 789
TOFFON, 789
TOFFR, 84
TOFRAME, 333
TOFRAMEX, 333
TOFRAMEY, 333
TOFRAMEZ, 333
TOLOWER, 450
Tool
change point, 35
change with M6, 64
change with T number, 64
cutting edge, 80
Group, 70
length compensation, 67
Offset memory, 69
-orientation, 769
-orientation for frame change, 785
-parameters, 739
radius compensation, 68
tip, 69
Type, 70
Type number, 70
Tool chain, 736
Tool offset
Coordinate system for wear values, 747
Offset, 84
Offset memory, 739
Tool offsets
additive, 741
Tool orientation
relative to the path, 687
Tool orientation relative to the path, 687
Tool radius compensation
At outside corners, 268
Corner deceleration, 624
CUT2DF, 288
Tool speed
maximum, 94
TOOLENV, 807
Toolholder
kinematics, 778
-orientable, 783
reference point, 35
Toolholder with orientation capability, 778
TOROT, 333
TOROTOF, 333
TOROTX, 333
TOROTY, 333
TOROTZ, 333
TOUPPER, 450
TOWBCS, 747
TOWKCS, 747
TOWMCS, 747
TOWSTD, 747
TOWTCS, 747
TOWWCS, 747
TRAANG
with programmable angle, 703
TRACON, 705
TRACYL, 700
TRAFOOF, 719
TRAFOON, 730
TRAILOF, 891
TRAILON, 891
TRANS, 310
Transformation types
General function, 654
Transformation with a swiveling linear axis, 664
Transformations
Chained transformations, 656
Concatenated, 705
Initial tool orientation setting regardless of
kinematics, 655
Kinematic transformations, 655
Orientation transformation, 654
Three-, four- and five-axis transformation, 665
TRANSMIT, 699
Transverse axis, 169
TRAORI, 665
Travel command, 170
TRUE, 397
TRUNC, 441
TU, 712
TURN, 204
Turning tools, 76
Type of coupling, 926
U
ULI, 409
Undercut forms E and F / undercut thread –
CYCLE940
External programming, 1119
UNTIL, 480
User XML, 992
Index
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 1333

Siemens SINUMERIK 804D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 804D sl
Category	Control Systems
Language	English