For the function areas listed below, the input and modification of data depends on the protection
level you have set:
● Tool offsets
● Work offsets
●
Setting data
● RS232 settings
● Program creation / program correction
You can set the protection levels for these function areas through the following key operations
(USER_CLASS...):
+ → → → →
Protection levels: 1, 3
Both of the two access levels require a password.
You can change the password only after an activation with the protection level 1.
If you forget
your password, you can carry out a start-up through the following operations (with
the manufacturer password):
+
1. Select the desired operating area.
2. Press this softkey to enter the main screen of start-up.
3. Press this softkey to enter the main screen of NC start-up.
4. Use the cursor keys to select the second start-up mode.
5. Press this softkey to confirm your selection.
This will reset all passwords to their defaults according to the software release you have
acquired.
Note
Before performing a
start-up with default data, you must backup your data; otherwise, you will
have your data lost.
Explanation of machine data and setting data
2.1 Data in the list
Parameter Manual
16 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
To Next Page
Loading...
Need help?
General
