Values substantially larger than 10 are only practical in exceptional cases.
Not only the value of MD28540 $MC_MM_ARCLENGTH_SEGMENTS but also that of MD20262
$MC_SPLINE_FEED_PRECISION are crucial for the accuracy.
28560 MM_SEARCH_RUN_RESTORE_MODE C02 K2
- Data restore after simulation DWORD PowerOn
-
- - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x00000001 1/1 M
Description: Bit mask to restore data after cancelation of a simulated program execution. The
following applies:
Bit 0: All frames in the data storage are restored.
3.4 Axis-specific machine data
30100 CTRLOUT_SEGMENT_NR EXP, A01 G2, S9
- Setpoint assignment: bus segment number BYTE PowerOn
-
808d-me42 1 0 0 0 ReadOnly
808d-me62 1 5 0 5 2/2
808d-te42 1 0 0 0 ReadOnly
808d-te62 1 5 0 5 2/2
808d-mte40 1 0 0 5 7/2
808d-mte60 1 5 0 5 7/2
Description: In this MD, enter the number of the bus segment through which the output is addressed.
0: Local bus (808d, 828d analog spindle)
1: reserved (previously SIMODRIVE611D bus, 1st DCM)
2: reserved (previously local P bus)
3: reserved (previously SIMODRIVE611D-Bus, 2. DCM)
4: reserved (virtual buses)
5: PROFIBUS/PROFINET (e.g. SINUMERIK 840Di)
6: reserved (same effect as 5)
30110 CTRLOUT_MODULE_NR A01, A11 G2, S9
- Setpoint assignment: module number BYTE PowerOn
-
808d-me42 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 2/2
808d-me62 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 2/2
808d-te42 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 2/2
808d-te62 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 2/2
808d-mte40 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 7/2
808d-mte60 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 7/2
Description: In this MD, enter the number of the module within a bus segment through which the
output is addressed.
For an axis on the PROFIBUS/PROFINET, the logical I/O address from MD13050
$MN_DRIVE_LOGIC_ADDRESS[index] is assigned by entering index+1 in MD30110
$MA_CTRLOUT_MODULE_NR.
Machine data
3.4 Axis-specific machine data
Parameter Manual
208 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
To Next Page
Loading...
Need help?
General
