Bit 16 - 19: Extension $AC_TOTAL_PARTS
-------------------------------------------------------------------------
Meaning of the bits 16-19 applies only if Bit4 =1 and $AC_REQUIRED_PARTS > 0:
Bit 16 = 0: $AC_TOTAL_PARTS is active in MDI mode
Bit 16 = 1: No machining $AC_TOTAL_PARTS in MDI mode
Bit 17 Reserved!
Bit 18 Reserved!
Bit 19 Reserved!
Bit 20 - 23: Extension $AC_ACTUAL_PARTS
-------------------------------------------------------------------------
Meaning of bits 20-23 only if bit8 =1 and $AC_REQUIRED_PARTS > 0:
Bit 20 = 0: $AC_ACTUAL_PARTS is active in MDI mode
Bit 20 = 1: No machining $AC_ACTUAL_PARTS in MDI mode
Bit 21 Reserved!
Bit 22 Reserved!
Bit 23 Reserved!
Bit 24 - 27: Extension $AC_SPECIAL_PARTS
-------------------------------------------------------------------------
Meaning of bits 24-27 only if bit12 =1 and $AC_REQUIRED_PARTS > 0:
Bit 24 = 0: $AC_SPECIAL_PARTS is active in MDI mode
Bit 24 = 1: No machining $AC_SPECIAL_PARTS in MDI mode
Bit 25 Reserved!
Bit 26 Reserved!
Bit 27 Reserved!
Related to:
MD27882 $MC_PART_COUNTER_MCODE
27882 PART_COUNTER_MCODE C09 K1
- Workpiece counting with user-defined M command BYTE PowerOn
-
- 3 2, 2, 2, 2, 2, 2, 2, 2, 2,
2, 2, 2, 2, 2, 2, 2, 2, 2,
2, 2, 2, 2...
0 99 3/2 M
Description: If part counting is activated via MD27880 $MC_PART_COUNTER, the count pulse can be
triggered by a special M command.
Only then are the values defined here taken into account:
Meaning:
The part counters are incremented by 1 in the NST signal output of the M command
described, where:
MD27882 $MC_PART_COUNTER_MCODE[0] for $AC_TOTAL_PARTS
MD27882 $MC_PART_COUNTER_MCODE[1] for $AC_ACTUAL_PARTS
MD27882 $MC_PART_COUNTER_MCODE[2] for $AC_SPECIAL_PARTS
27920 TIME_LIMIT_NETTO_INT_TASK EXP, C01 -
s Runtime limit of interpreter subtask DOUBLE PowerOn
-
- - 0.005, 0.005, 0.005,
0.005, 0.005, 0.005,
0.005, 0.005...
0.001 0.100 ReadOnly S
Machine data
3.3 Channel-specific machine data
Parameter Manual
196 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
To Next Page
Loading...
Need help?
General
