32910 DYN_MATCH_TIME A07 G1, K3, S3, A2, A3, G2, S1, V1
s Time constant of dynamic response adaptation DOUBLE NEW CONF
-
- 6 0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.0 - 1/1
Description: The time constant of the dynamic response adaptation of an axis has to be entered in
this MD.
Axes interpolating with each other but having different dynamic responses can be
adapted to the "slowest" control loop by means of this value.
The difference of the equivalent time constant of the "slowest" control loop to the
individual axis has to be entered here as the time constant of the dynamic response
adaptation.
The MD is only active if MD32900 $MA_DYN_MATCH_ENABLE = 1.
Related to:
MD32900 $MA_DYN_MATCH_ENABLE (dynamic response adaptation)
33050 LUBRICATION_DIST A03, A10 A2, Z1
mm, degrees Traversing path for lubrication from PLC DOUBLE NEW CONF
-
- - 1.0e8 0.0 - 3/3
Description: After the traversing path defined in the MD has been covered, the state of the axial
interface signal "Lubrication pulse" is inverted, this can activate an automatic
lubrication device.
The traversing path is summated after Power on.
The "Lubrication pulse" can be used with axes and spindles.
Application example(s):
The machine bed lubrication can be carried out as a function of the relevant traversed
path.
Note:
When 0 is entered, the NC/PLC interface signal DB390x DBX1002.0 (Lubrication pulse) is
set in every cycle.
Related to:
NC/PLC interface signal DB390x DBX1002.0 (Lubrication pulse)
33100 COMPRESS_POS_TOL A10 F2, B1, K1
mm, degrees Maximum deviation during compression DOUBLE NEW CONF
CTEQ
808d-me42 - 0.1 1.e-9 - 1/1
808d-me62 - 0.1 1.e-9 - 3/3
808d-te42 - 0.1 1.e-9 - 0/0
808d-te62 - 0.1 1.e-9 - 0/0
808d-mte40 - 0.1 1.e-9 - 7/7
808d-mte60 - 0.1 1.e-9 - 7/7
Description: The value specifies the maximum permissible path deviation for each axis with
compression.
The higher the value, the more short blocks can be compressed into a long block.
Not relevant for:
Active programmable contour/orientation tolerance (CTOL, OTOL, ATOL)
Machine data
3.4 Axis-specific machine data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 255
To Next Page
Loading...
Need help?
General
